Skip to content
Close

10mm 4 Pin 5050RGB Strip to Strip Unwired Gapless Solderless Connector, Dual End

  • Compatible with both Non-Waterproof and Waterproof SMD 5050 RGB LED strip lights that are 10mm in width. For example, it works for DAYBETTER, SUPERNIGHT, econoLED, eTopxizu,WenTop, LEDMO and Tingkam RGB 5050 LED strips, etc. When you use the connectors on your waterproof SMD 5050 RGB LED strip, you need to first remove the waterproof coating around the cutting line on your waterproof LED strip.
  • These connectors are made of PVC, which is flame retardant and durable, thus ensuring personal safety and a longer service life.
  • Simple but effective, tool free, easy installation, seamless extension by snapping system, making a neat and good looking layout around a sharp corner, couldn’t be easier using these connectors.
  • Working voltage: DC 0-24V. Working current: 0-6A.
Categories: , Tag:

Precautions before installation:
When you cut your LED strip into 2 LED strips, you should cut very carefully along the cutting line, to make sure the area of the copper contacts on the 2 LED strips are the same. (not a bigger area of copper contacts on one LED strip, and a smaller area of copper contacts on the other LED strip.). If the area of the copper contacts on the LED strip is too small, the 4 electrical conductors in the connectors can not totally touch the 4 copper contacts on the LED strip, and there will be poor electrical conductivity. As a result, you may get 2 different colors or even get no colors at all.

Installation Instructions:
1. Ensure your LED strip is 10mm wide 4 pin RGB 5050 LED strip and has 4 copper contacts (+, G, B, R).
2. Carefully cut your LED strip along the cutting line.
3. Open the cap of the connector.
4. If you use a non-waterproof LED strip, please insert the LED strip into the connector. Make sure the 4 copper contacts on the LED strip are under the 4 electrical conductors in the connector. Make sure to match the + side of the LED strip to the + side of the connector;
If you use a waterproof LED strip, please first remove the silicon around the cutting line, then insert the LED strip into the connector. Make sure the 4 copper contacts on the LED strip are under the 4 electrical conductors in the connector. Make sure to match the + side of the LED strip to the + side of the connector.

Related products